Preskoči na sadržaj
Kelco — elektronske komponente
Single 12V 2A DC PWM 3 Wire Fan Temperature Control, Speed Controller Driver Module — šifra 24570 | Kelco Single 12V 2A DC PWM 3 Wire Fan Temperature Control, Speed Controller Driver Module — šifra 24570 | Kelco — slika 2

Single 12V 2A DC PWM 3 Wire Fan Temperature Control, Speed Controller Driver Module

Šifra: #24570 Oznaka: FAN TEMP CTRL 3P
Na stanju
1.176,10 RSD po komadu, sa PDV-om

Do −30% na veće količine

Cena po komadu: 1.176,10 RSD Ukupno: 1.176,10 RSD
Cena po količini
Količina Cena po komadu Ušteda
1–9 kom 1.176,10 RSD —
10–99 kom 1.058,48 RSD −10%
100+ kom 823,26 RSD −30%

Popust se obračunava po stavci — prema količini ovog artikla u porudžbini, ne prema ukupnoj vrednosti korpe.

Opis

Precautions for use:

Since most fans can run but cannot start at low output, when setting the minimum speed of the temperature control, you should first adjust to the lowest speed and stop the fan by hand, and then increase the output step by step until the fan starts normally. Don't go below this position after the actual setting, otherwise the fan may not start when the speed is low.

Specifikacija

Specifikacija
Working voltage DC12V (9-14V range)
Input reverse connection protection Yes
Power interface XH-3P terminal block (pin spacing 2.54mm)
Fan current 0.8A (not overloaded)
Fan interface KF2510-3P terminal block (pin spacing 2.54mm)
Temperature probe parameters NTC 50K B=3950 Length= 50cm
Temperature probe interface XH-2P terminal block (pin spacing 2.54mm)
Temperature probe temperature resistance Ring probe 110℃
PWM output range 5%-100%
Working temperature -20℃ - +60℃
Size 43mm X 18mm x 9mm

Dostupno u prodavnici

Bulevar kralja Aleksandra 326
11050 Beograd
Ulaz iz Slobodanke Danke Savić
Ponedeljak – Petak: 09:00–17:00
Subota: 10:00–15:00
+381 11 2403-376 +381 11 2403-387

Iz iste kategorije

12V Thermal Sensor Module

#24660
Na stanju
418,02 RSD
do −30% na količinu
Cena po komadu: 418,02 RSD

Dodato u korpu ,